5\u2013100 t steel selection / weighbridges & silos
Double-Ended Shear Beam Load Cells
Two end supports and center loading create a different installation from a single-ended beam. Specify the center-link or ball-cup arrangement, freedom of movement and structural restraints.
Steel Double-Ended Shear Beam Load Cell
5–100 t / 10,000–200,000 lb
Truck weighbridges, heavy hoppers and silos
Select configurationStainless Double-Ended Shear Beam Load Cell
5–100 t / 10,000–200,000 lb
Outdoor weighbridges and corrosive-process weighing
Select configurationAluminum Double-Ended Beam for On-Board Weighing
Application-specific; submit axle and payload loads
On-board vehicle weighing and lightweight platforms
Select configurationEnd supports and center load introduction define the interface.
Compare support span, end-hole pitch, load height and the specific cup, steel ball, saddle or link. Preserve the movement and restraint clearances specified by the mounting drawing.
Evaluate dead load, uneven vehicle positioning, braking, impact and wind reactions. A single-ended platform foot is not a substitute for a double-ended center loading assembly.
Stationary steel and on-board aluminum need different reviews.
The 5–100 t range describes the steel selection scope. SBL-ALU is an application-specific vehicle configuration requiring chassis, shock, fatigue and braking-load review.
Specify cable length, four- or six-wire functions, sensitivity and resistance for parallel operation. For 6–10 supports, choose enough summing-box channels and perform system calibration after installation.
DIMENSIONS. LOAD PATH. SIGNAL.
Get the complete weighing kit specified.
Send capacity per cell, support count, thread standard and your existing drawing.